Nema 17 Stepper Motor 17HS19-1684S1 2.8V 1.8 deg 45Ncm 4 Wires
-
Manuals and Documentation:
Full Datasheet:
Torque Curver:
Nema 17 Stepper Motor 17HS19-1684S1 2.8V 1.8 deg 45Ncm 4 Wires
This bipolar Nema 17 stepper motor with step angle 1.8deg and size 42x42x48mm. It has 4 wires with 1m cable and 2.54mm pitch connector, each phase draws 1.68A, with holding torque 45Ncm (64oz.in). It's very good choice for 3D printer.
Electrical Specification
- Manufacturer Part Number: 17HS19-1684S1
- Motor Type: Bipolar Stepper
- Step Angle: 1.8 deg
- Holding Torque: 45Ncm(64oz.in)
- Rated Current/phase: 1.68A
- Voltage: 2.8V
- Phase Resistance: 1.65ohms
- Inductance: 2.8mH ± 20%(1KHz)
Physical Specification
- Frame Size: 42 x 42mm
- Body Length: 48mm
- Shaft Diameter: Φ5mm
- Front Shaft Length: 24mm
- Number of Leads: 4
- Lead Length: 1000mm
- Weight: 390g
Connection
A+
|
A-
|
B+
|
B-
|
Black
|
Green
|
Red
|
Blue
|
Electrical Specification | |
---|---|
Bipolar/Unipolar | Bipolar |
Holding Torque (Ncm) | 45 |
Holding Torque (oz.in) | 63.7 |
Inductance(mH) | 2.5 |
Phase Resistance(ohm) | 2 |
Rated Current (A) | 1.68 |
Step Angle(°) | 1.8 |
Physical Specification | |
Body Length(mm) | 48 |
Frame Size(mm) | 42x42 |
Single Shaft/Dual Shaft | Single Shaft |
Shaft Type | D-Cut |
Shaft Diameter(mm) | 5 |
Shaft Length(mm) | 24 |
No. of Lead | 4 |
Lead Length(mm) | 1000 |
Weight(g) | 400 |
- Connectors: Molex, Harwin, Tyco/AMP, JST etc.
- Lead wires & cables: Special lengths, Protective hose
- Shaft: Round, D-Cut, Cross drilled, Key-Way, Thread or Hollow
- Winding: Resistance, Inductance, Rated Current, etc.
- Connectors: Molex, Harwin, Tyco/AMP, JST etc.
- Lead wires & cables: Special lengths, Protective hose
- Shaft: Round, D-Cut, Cross drilled, Key-Way, Thread or Hollow
- Winding: Resistance, Inductance, Rated Current, etc.