4 Axis CNC Router Kit 1.26Nm (Nema 23 Stepper Motor + TB6560 Driver + Power Supply)
-
Manuals and Documentation:
Driver Manual:
Motor Datasheet:
Power Supply Manual:
4 Axis CNC Router Kit 1.26Nm (Nema 23 Stepper Motor + TB6560 Driver + Power Supply)
This CNC kit included:
- 1 x 4 Axis TB6560 CNC Stepper Motor Driver Board
- 4 x 1.26Nm (178.4oz.in) of Nema 23 Stepper Motor
- 1 x 250W 24V 10A 115/230V Switching Power Supply
- 1 x DB25 Parallel Cable & Manual CD
4 Axis TB6560 CNC Driver Board
- Toshiba TB6560AHQ chip - High power, maximum current 3.5A
- Resolution 1, 1/2, 1/8, 1/16 micro stepping output
- Working voltage DC12-DC30V, rated voltage 24V
- Adjustable current with 100%, 75%, 50%, 20% of full current by on-board switch.
- Half current function when no signal to prevent motor heating.
- Build with a 227V 10A Relay.
- Manual Control circuit included.
- Overload, over-current and over-temperature safety.
- Protect the computer by using isolating power(1000V DCDC) and optoelectronic coupler.
- Supports most parallel software MACH3, KCAM4, EMC2 etc.
- Fixed in Aluminum box, better cooling function than fan and safer protection for board circuit.
Stepper Motor
- Manufacturer Part Number: 23HS22-2804S
- Motor Type: Bipolar Stepper
- Step Angle: 1.8 deg
- Holding Torque: 1.26Nm(178.4oz.in)
- Rated Current/phase: 2.8A
- Voltage: 2.5V
- Phase Resistance: 0.9ohms
- Inductance: 2.5mH ± 20%(1KHz)
- Frame Size: 57 x 57mm
- Body Length: 56mm
- Shaft Diameter: Φ6.35mm
- Shaft Length: 21mm
- Number of Leads: 4
- Lead Length: 500mm
- Weight: 700g
Switching Power Supply
- 24V DC 10A output
- AC input voltage range: 90~132V/180~264VAC
- 115V/230V AC selected by switch
- Forced air cooling by built-in DC fan
- Low output ripple and yawp
- Over current, over voltage, short circuit and overheat protections
- 215*115*50mm (L*W*H)
Motor Specification | |
---|---|
Step Angle(°) | 1.8 |
Body Length(mm) | 56 |
Holding Torque (Ncm) | 126 |
Holding Torque (oz.in) | 178.4 |
Inductance(mH) | 2.5 |
Lead Length(mm) | 500 |
Motor Nema Size | Nema 23 |
No. of Lead | 4 |
Phase Resistance(ohm) | 0.9 |
Rated Current (A) | 2.8 |
Shaft Diameter(mm) | 6.35 |
Shaft Length(mm) | 21 |
Stepper Driver Specification | |
Driving Voltage(V) | 12 - 30 |
Output Current(A) | 0.7 - 3.5 |
Microstep(Steps/rev.) | 200 - 3200 |
Max. Pulse Input(kHZ) | 40 |
Physical Specification | |
Weight(g) | 5000 |